Reach Barrier 3009 Guide d'installation télécharger pdf

REACH Barrier LLC. 860 N. Dorothy Dr., Suite 608 - Richardson, TX 75081 - 972-331-3933

www.reachbarrier.com - sales@reachbarrier.com

REACH Barrier – Garage Door Insulation Kit Install Instructions:

Practice/Step 1: It is best to use the extra size of

the panel to help hold the panel in place. Simply

“push” and “move” the panel in the proper position

within the panel to the desired fit (before using

the Stick’ems™ adhesive squares!) Once you

“see” how the panels will fit proceed to the next

step.

Step 2: Peel off backing of a Stick’ems™ and

stick one (1) in each of the four corners of the

garage door panel and one (1) or two (2) in the

center as shown. Once the Stick’ems™ have

been stuck to the door peel off the top layer of

paper to reveal the other sticky surface below.

Step 3: Once you have the Stick’ems™ in place

and removed the paper to reveal the sticky

surface, the radiant barrier panels can be pushed

into place.

Finish: Stick’ems™ require 24 hours to become

fully stuck.

Begin by cleaning the surface of the

inside door panels where the adhesive

squares (Stick’ems™) will be used to

hold the radiant barrier panels in

place.

NOTE: There are eight (8) radiant barrier

panels in the kit. Each panel is 4 feet in length.

It is recommended that you use (5-6)

Stick’ems™ per panel. 48 squares are included

in your kit to complete the installation.

For improved thermal performance, add 3/4” air space

between Reflective Air and door. This can be done by

attaching to door framing rather than to the door panel

Kit # 3009

NOTE: There is no “right side” to the panels

– Just pick the side you wish to look at

REACH Barrier LLC. 860 N. Dorothy Dr., Suite 608 - Richardson, TX 75081 - 972-331-3933 www.reachbarrier.com - [email protected]

Pas de commentaire

Reach Barrier 3009 Guide d'installation